thanks guys
Quote:
Originally Posted by The_Law
nice, how much did you find the whipple for?
|
i got the motor with the whipple, harness and ECM with shorty headers msd wires and low temp thermostat for 3300 plus about 150 in gas to go get it the next state over
Quote:
Originally Posted by LiftedLQ9
post up the dyno graph!
|
i will but unfortunately i dont have the printout of the max run we were kind of busy in the middle of it
Quote:
Originally Posted by Liftedz71
I see you still have the stock obs style cluster was it hard to incorporate that with the new lq4 harness? Also how are you going to fix your speedo? Its a beast.
|
-the oil pressure sensor was a direct clip in fit so no trouble with that
-i got an adapter for the water pressure so i could reuse the old sensor and that worked
-the gas gauge has been reading beyond full, i think there is a ground missing in that circuit i still have to chase it down but i just keep a full tank no problems there
- tach i directly wired the ECM tach output to the big green wire going to the cluster and after adjusting the pulse output in EFILIVE its working properly
- speedo i wired the speedo output to the big green wire in the dash but im pretty sure thats actually the high beam indicator light so i have to reopen the dash and try a couple different wires, one of them is bound to be the speedo hah (my phone gps gives me mph output lol and i know that 2k in 4th is 75 mph)
Re: supercharged 6.0 obs on the dyno
