[cubhunter2297]

Thinking about buying the rcx 5in for my truck and putting 33s on it, the question is will my tires rub with the 20x12 -44 offset Moto metal 962s rims with 33s on them? If so how much trimming?

 

[JDFarmer94]

I'm running a 5 inch RCX with a 1" TGC lower spacer. I had to remove the valance and trim a little corner off of my bumper and pulled my inner fender forward. The rub a little on the rear inner fender with no modification. Without the 2" leveling kit, it wouldn't work worth a damn.

 

[brucebruce45]

It will rub alot

 

[cubhunter2297]

Yea my truck is leveled already, so what is that spacer then? And can you take a picture of where you trimmed?

 

[JDFarmer94]

Yea my truck is leveled already, so what is that spacer then? And can you take a picture of where you trimmed?

If you have a upper strut spacer you cant run it with the RCX. You have to run a lower strut spacer like this 2" leveling kit.
I will get pictures of what I trimmed on my bumper.

 

[JDFarmer94]

Ignore the grim and rust. Its winter time

I guess I did trim a little off the fender liner in the back. It rubs in reverse sometimes.

 

[cubhunter2297]

Im pretty sure that is the level kit i have its rough country i bought the truck with it on it, but their is no spacer on the top, ill give it a better look tomorrow, so can you turn your wheel both ways with out rubbing?

 

[JDFarmer94]

Im pretty sure that is the level kit i have its rough country i bought the truck with it on it, but their is no spacer on the top, ill give it a better look tomorrow, so can you turn your wheel both ways with out rubbing?

Yes just rubs while turning in reverse.

 

[cubhunter2297]

So i think im going with the kit and the 20x10 moto metals

 

[Gator]

....................