GMC Truck Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Have no idea what could possibly be my issue but I have an 09 tahoe that I'm lowering 4/6. Belltech drop struts and 2511 drop spindles in the front. I have the Belltech camber kit installed with the offset hole in the bushing pointed away from the ball joint like it is supposed to be because I was expecting a lot of negative camber. Well not even close to the case apparently. I actually have my cams maxxed all the way in towards the frame and not out where I clearance the slot holes. And with a full load on the truck I still have about 4 degrees of positive camber. I don't get it it didn't make any sense. All my control arm bushings in the lower a arm are in good condition also. Anyone have any idea what the hell the problem is or have seen this before?
 

Attachments

1 - 1 of 1 Posts
Top