GMC Truck Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter · #1 ·
Its All Lined Up Pretty Good, So Now Its Time To Grind Down All The Ifs Brackets, And Start Cleaning The Frame. I Did All The Cutting With A $20.00 4" Angle Grinder From Harbor Freight.

IMG_0304_zpseaf9ca71.jpg


I Went A Little Deep On Some Brackets, So I Threw Some Flux-Core Over Them And Ground Them Down.

IMG_0307_zps2143ba07.jpg


IMG_0308_zps6291fdfc.jpg


IMG_0309_zps1375a553.jpg


Couple Rainy Days Went By So I Preped/Grinded Down My Frame To Make It Smooth For Some Paint. I Went With P.O.R15 And Painted My Whole Frame Inside And Out Back To Front. Got My U-Bolts Made Finally And My U-Bolt Plates & HardWare Finally Came In.

IMG_0322_zps39f9d545.jpg


IMG_0325_zps8fc279f0.jpg


IMG_0327_zpsb0171e78.jpg


Will Post More Tomorrow
Thanks For Being Patient

Kyle
 

·
GMFS Member
Joined
·
749 Posts
Bruh you can make more than one post in a thread, it's not necessary to make multiple threads. This should be interesting :popcorn:
 
1 - 2 of 2 Posts
Top