GMC Truck Forum banner
1 - 2 of 2 Posts

·
03 Tahoe
Joined
·
1,364 Posts
groundscraper said:
2" drop springs for the front. Do not put in dropped control arms with dropped spindles on a static drop.

You'll have to re-install your stock S/H units for the rear and add the flip kit for a 6" drop.
:word:

As far as replacing the overload spring...you don't need to but it won't hurt. Kinda depends if you wanna haul stuff around. I probably wouldn't bother with putting it back in since if you really wanna haul a good load with a 4/6 you'd want to install a air assist kit anyhow.

Cameron
 

·
03 Tahoe
Joined
·
1,364 Posts
A drop spindle w/ a drop arm would make the drop arms run so low to the ground.....not to mention would probably rub the inner lip of the rim if it would even rotate.

Cameron
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top