GMC Truck Forum banner

1 - 20 of 20 Posts

·
Registered
Joined
·
333 Posts
Discussion Starter · #1 ·
Whats everybody putting in the lil slot in the front bumper? Any certain brackets needed? I see that 20" is about the max.... any help is welcomed
 

·
Registered
Joined
·
289 Posts


I've got a 20" double row in mine had to red till the mounting holes on the bracket about 1" lower


Sent from my iPhone using Tapatalk
 

·
Friendly Funeral Director
Joined
·
529 Posts
Mine had a double row 20 inch and it was a bolt in really! Pull the brill and pad. Unbolt 2 bolts in the bumper that are at the edges of the hole in bumper. Assemble the light bar and drill the mounting holes out to fit the stock bolts. Then place Ling on bolts and bolt down with stock nuts. Adjust light bar. And wire in

Sent from my SM-N900V using Tapatalk
 

·
Friendly Funeral Director
Joined
·
529 Posts


Sent from my SM-N900V using Tapatalk
 

·
Friendly Funeral Director
Joined
·
529 Posts
Just drilled the factory light bar mounts they bolt right up

Sent from my SM-N910V using Tapatalk
 

·
Registered
Joined
·
9,795 Posts
my old truck and lightbar, loved it.
image_14.jpg
 

·
High N Low
Joined
·
82 Posts

20" rigid industries SR series and the rigid industries mount


Sent from my iPhone using Tapatalk
 

·
Master of Light
Joined
·
206 Posts
If your bar has side-mounts, you can easily built your own brackets from 1" Angled aluminum from most hardware stores. Cost maybe $10 plus an hour of additional measuring/cutting/painting.

IMG_6224_zpsygmvik9c.jpg


IMG_6230_zps3wsb434s.jpg


IMG_6229_zpscdljwszj.jpg
 
1 - 20 of 20 Posts
Top