GMC Truck Forum banner
1 - 16 of 16 Posts

· Rusty Shackleford
Joined
·
398 Posts
Discussion Starter · #1 ·
I have a set of 24x10" Ultra Goliath wheels in 8 on 6.5 bolt pattern (8 lug hd) powder-coated gloss GM black, with Pirelli Scorpion ATR's(325x45x24). The wheels are essentially blemish free and are close to a stock offset. Two of the tires have 7-10 32nds of tread life left, and two are around 1-2 in the centers and 5-7 on the sides. These wheels are around $450 each new plus the powder-coat.

They are located in Bettendorf, Iowa.

$1000 + Shipping for the tires and wheels or just the wheels







 

· GMFS Member
Joined
·
767 Posts
you think these would rub on a NNBS with a rear leveling kit
 

· GMFS Member
Joined
·
767 Posts
Ok...I might be interested. Right now I still am trying to save up so whatever rims I decide to go with I can afford up front. I'm really hoping to find some 22" SS replicas, but if I dont find any of those by the time I have enough saved, I'll probably check back with you. Your truck is clean man
 

· AKA Sugar Plum
Joined
·
4,612 Posts
Ok...I might be interested. Right now I still am trying to save up so whatever rims I decide to go with I can afford up front. I'm really hoping to find some 22" SS replicas, but if I dont find any of those by the time I have enough saved, I'll probably check back with you. Your truck is clean man
dude.... your truck is 6 lug.
 

· Registered
Joined
·
1 Posts
I have a set of 17" goliath I want to powder coat what did you do with the center cap did you buy new black ones or did you paint it or what?
Do you have a suggestion of what tires to put on with them all i have is a leveling kit on my Sierra.

Thanks
 
1 - 16 of 16 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top