GMC Truck Forum banner
1 - 20 of 26 Posts

·
Registered
Joined
·
97 Posts
Discussion Starter · #1 ·
Looking for something rite around 8" but would settle for anything 6-9" Cognito has the 7-9 but everywhere else is about 4" what are my options? Thanks
 

·
Registered
Joined
·
8,384 Posts
pro-comp and fabtech both have a 7" crossmember kit for the 2wd trucks. Not sure if adding a spacer/spindle for additional height is possible though. Someone else should know
 

·
Registered
Joined
·
97 Posts
Discussion Starter · #4 ·
my truck I just got a 3in BL from Zone and did a 4in rear block, 3in spindles and 3in lift coil so Thats basically 7 and 9
I was actually thinking about doing this I already have some 3" spindles and was thinking about ordering some coils. Do you happen to have any pictures of your truck?
 

·
Registered
Joined
·
13 Posts

6 inch procomp drop down bracket w/ coils and spindles with a 1 inch block in the rear.
315/70/17 Falken Rocky Mountain At / S , and Mb 72 matte black 17 inch x 8 wheels.
minimum trim on front valance, Falken at/s have to be more quiet than my 2011 altima tires. i love the tires

SO CAL A RIFIC
 

·
2wd-RazorbackChevy
Joined
·
1,888 Posts
I was actually thinking about doing this I already have some 3" spindles and was thinking about ordering some coils. Do you happen to have any pictures of your truck?
a few. I will post some after work today. I will pm you
:shake:

EDIT: i have one on my profile page but it's not a very good one cuz its a distant shot and the damn coconut tree is in the shot :crazy:
 

·
2wd-RazorbackChevy
Joined
·
1,888 Posts
My camber was off in these pics so the front wheels are cocked a bit. It's fixed now and i can take updated pics if needed.






damn coconut tree lol








lift- 3" spindle, 3" coil, 4" block, 3" BL
wheels/tires- 16x8 Eagle 186 / Kelly Safari TSR 315/75-16

EDIT: and yes, i took off the gay ass halos :crazy: i have crystal clears now
before you ask, thats my neighbors Ford Escort....... lol
 
1 - 20 of 26 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top