GMC Truck Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
ok i cant seem to figure ohms out very well and dont want to damage my amp. i have an old style usacoustics 2150 which breaks down to

150wx2ch @4ohms
250wx2ch @2ohms
500wx1ch @4ohms bridged

right now its wired with 150w @4ohms. one channel to one voic coil and the other chanel to the other voic coil. the sub is a niche audio 12" nw12e dvc 4ohms.

is this the best way to wire it? i have people telling me more than one way so im not sure wich is the best way to get the most out of my combo. thanks!
 

·
Wanna B Jack o all Trades
Joined
·
9,823 Posts
Id bridge it, but its only going to get 250. Your running it in stereo right now. Id run a wire from the + of VC1 to the - of VC2 and then use the left over + and - to the bridged outputs of the amp. If not you might get slight differences between the 2 sides and subs dont like that
 
1 - 3 of 3 Posts
Top