GMC Truck Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter · #1 ·
anybody ever use these?? http://www.amazon.com/ACDelco-45K403...ywords=45K4032

I'm looking to gain some negative camber and negative caster, not quite sure how they install or if they're any good. Camber is cuttently +1.0 negative and caster is +5.8-6.0 degrees, alignment cams are maxed. Any insight is appreciated.
 

·
Premium Member
Joined
·
2,287 Posts
anybody ever use these?? http://www.amazon.com/ACDelco-45K403...ywords=45K4032

I'm looking to gain some negative camber and negative caster, not quite sure how they install or if they're any good. Camber is cuttently +1.0 negative and caster is +5.8-6.0 degrees, alignment cams are maxed. Any insight is appreciated.
Two things:

1. Linky fail
2. Do you have the MOOG offset upper control arms yet?
 

·
Registered
Joined
·
83 Posts
Discussion Starter · #3 ·
[ame="http://www.amazon.com/ACDelco-45K4032-Professional-Suspension-Assembly/dp/B00S0AM0FU/ref=sr_1_1?ie=UTF8&qid=1428948919&sr=8-1&keywords=45K4032"]Amazon.com: ACDelco 45K4032 Professional Front Upper Suspension Ball Joint Assembly: [email protected]@[email protected]@http://ecx.images-amazon.com/images/I/[email protected]@[email protected]@41-RTy-pUrL[/ame]

I'm using MMW upper control arms, so the bushing cups are not the same as the stock control arms. Offset bushings wouldn't fit. I do have a set of uppers with offset bushings in them but I don't want to go back to stock arms if at all possible.
 
1 - 3 of 3 Posts
Top