[roller]

Just bought a zone 3" body for my 2013 crew cab 1500, question I have is, how are my amp steps going to clear the middle body mount, it doesn't even look like I can trim it enough to clear once the body lift is on, any help would be great, pics would be better, if someone could post one up of a trimmed one.

Looks like it would still hit on the big washer on body mount bolt after you trim.

 

[Riggs]

You can trim the body mount I've seen it done before and it will work

 

[Riggs]

I trimmed this idiots body mounts since that was the only way to make it work and had to draw up custom brackets in cad and have them lasered out for his gay bumper too at my last job all that money and couldn't buy a decent lift

I think I just cut off about 1/2" on the round part

 

[roller]

Ok thanks, anybody have a picture of it. I'm asking because if you have to cut a ton of material off I might cut the whole mount off and move it up 3".