GMC Truck Forum banner

auto trac issues

583 Views 0 Replies 1 Participant Last post by  Dylan1987
went to change encoder motor on my truck and can't get the new 1 on because the shaft coming out of transfer case spins but just springs back when i let go. and it takes some force even with a crescent wrench Does anyone know if this is normal? also have any of you guys encountered this and how did you fix it? Thanks in advance!
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.