I just bought my 2006 2500 last week. It came with a keyfob but all it did was flash the lights and make the siren go off. Since my truck is a WT so no power anything I knew this had to do more. Took the panel under the dash off and found the C3-RS730 module installed. Now here is where I need help, first they had the orange plug for the 2 stage shock sensor zone 4 ran under the truck to the tailgate and there the wires were cut?? Second when I hit the remote start button the lights turn on, the cel light comes on, I hear the fuel pump kick on and relays click and nothing, no cranking or anything. Any ideas? I've checked all the wiring and it seems to have good connections everywhere
I'm not familiar with Autopage, but here's what I think. Sounds like the start wire from the remote start isn't connected, or putting out 12V during the start sequence.
If the PasslockII wasn't programmed, it would still crank. ibanender recommended inserting the key into the ignition without turning, but in this truck you need to turn the key to the "on" position for it to start without the passlock II programmed.
If it does crank, and the passlock (padlock icon) on the instrument cluster is flashing, it means the passlock isn't programmed.
The wires being cut for the shock sensor shouldn't affect the remote start.
