GMC Truck Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
I have a 2004 GMC Sierra 2500HD with 285/75/16 BFG All Terrains on stock pyos and they have been balenced twice and at 40 to 50 miles an hour the whole truck shakes real bad. I don't think it's normal because friends truck with the same set up ride better. What should I look for because I'm lost on what to do. Thanks

Sent from my HTC ONE using Taptalk
 

·
Registered
Joined
·
6,401 Posts
shocks good? ball joints? tie rods? pitman and idler arms? when was the last time you had an alignment?
 

·
Registered
Joined
·
76 Posts
Discussion Starter #3
Idler arms is new and alignment was done both times the tires were ballenced no play in the front end I checked recently but I will check again. Could it be a bad belt in the tire?

Sent from my HTC ONE using Taptalk
 

·
Registered
Joined
·
8 Posts
Did you ever figure out what was wrong with yours? My 02 ecsb is doing the same thing around 40-45 and then as you get to 50 on up it stops.
 
1 - 8 of 8 Posts
Top