GMC Truck Forum banner

Been a little busy this week!

1074 Views 11 Replies 9 Participants Last post by  BuiltNotBought99
I started on my top dash this week as well as the back wall plastic and the pillars. I've been taking some pics along the way.


Looks good huh? :crazy:

Half way through with the 120!



Pillars


Finished with the 120!

Got a little touching up to do.




Instead of hand sanding that little line on the side I put some bondo on it.



Sanded down

My very first fiberglass job! I fiberglassed over the childseat thing holes on the back wall plastic.




I should be through with by next week sometime and then I can get it to my painter. If I can find somebody that can airbrush I'm going to get some ghost flames on the dash. Still not sure yet though.
1 - 12 of 12 Posts

· Burning Rubber
Joined
·
1,019 Posts
I have that same exact sander.... what Grit's have you gone through??

are you handsanding any of it?
 

· Registered
Joined
·
23,100 Posts
Discussion Starter · #9 ·
Chris99GMC said:
I have that same exact sander.... what Grit's have you gone through??

are you handsanding any of it?
I started with 120 grit and some 80 too! For some bad areas! But I sanded everything with the 120 and then went to 220 and then 220 wet. Next week I'll be using 600 and then 600 wet.
 

· Registered
Joined
·
1,473 Posts
I like it! Can I drop off my truck and expect it done next week? :jester:
 

· Registered
Joined
·
23,100 Posts
Discussion Starter · #11 ·
1TRUESS said:
I like it! Can I drop off my truck and expect it done next week? :jester:
You wish!! Nah I'd help ya out if you lived closer! :shake: A friend of mine is going to get a new Avalance pretty soon with the body molding and wants me to help him sand all that shit! That'll be a job and a half! But I'd rather do big flat parts than something with lots of nooks and corners.
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top