GMC Truck Forum banner
1 - 3 of 3 Posts

·
NNBS Owner
Joined
·
872 Posts
Discussion Starter · #1 ·
how hard is this belltech cam kit to put on nnbs trucks?? i looked up under and it looked like the coil/strut might need to be taken out to be able to get a grinder in there to slot the holes. and im also a little confused about where i actually need to grind material off of to have more adjustment. i have positive camber not negative and the instructions only kinda show where to grind for if you have too much negative camber. i would appriciate some help please and thanks
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top