GMC Truck Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
293 Posts
Discussion Starter #1
I want to install some Bilstein 5100's on my truck. I have the RC 2" leveling kit on now, but want to put a 1" block in the rear. The part numbers I have are BE5-E376-HO (Front) and BE5-E377-HO (Rear). Will these work on a stock truck, and also a truck with a 2" levelign kit up front and 1" block in the rear?
 

·
Registered
Joined
·
293 Posts
Discussion Starter #2
Bump
 

·
Bayou Surface Drive, LLC
Joined
·
7,077 Posts
Search mulitple sites for your application if part numbers are consistent then your Okay!
 

·
Registered
Joined
·
445 Posts
i currently am running the bilstein shocks that you are talking about. well at least in the front. they are what leveled my truck. so you might want to be careful to make sure they are set at the stock height if your going to be running them with the RC leveling kit.
 

·
Registered
Joined
·
293 Posts
Discussion Starter #5
Same part#? How does it ride compared to stock? Was it just the shock or did it come with a new spring as well?
 

·
Registered
Joined
·
445 Posts
rides pretty good. pretty close to stock but a little stiffer. it only comes with the shock. you have to use your stock coil and parts from the stock strut.
 
1 - 6 of 6 Posts
Top