GMC Truck Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a 17 Sierra 1500 SLT 4WD, Today I picked up my truck after installing a 9 inch Belltech lift with 22x10s on 33s. About 30 minutes after picking it up the CV axle on the driver side snapped after doing a 3 Point turn and it appears the passenger side CV axle was rubbing against the Shock. The angle of the cv axle doesn’t appear to be crazy? What could cause this?
 

·
Registered
Joined
·
71 Posts
If the cv axle is rubbing on the shock, then either the lift kit isn't designed for a 4wd model, or it's been installed wrong.

From that pic, it kinda looks like shock mount was just welded on that LCA. Perhaps go through the installation instructions for the lift kit and see what it says about the shock and how it's mounted there...
 
1 - 2 of 2 Posts
Top