GMC Truck Forum banner

1 - 10 of 10 Posts

·
nbs 2wd single cab
Joined
·
373 Posts
Discussion Starter #1
Didn't know where to post this question, so I'm posting here because I get a lot of help in here. I don't have the right tip to lower my spare tire in my jack pack. According to the picture on it I have all three extensions and the lug wrench. But I don't have the one that works the wench. I asked a guy at work today that also has a nbs Silverado if I could borrow his. He also didn't have the right end according to the picture. I have the end that drives the bottle jack, but that's not working the wench. According to the picture on the package, the piece I need should be completely flat like a common screwdriver. Can someone post a picture of the end that drives the wench so I can try to find one. Or better yet, if someone is in North Dallas, could I borrow it for 5 minutes? I won't carry a spare tire any longer, so I'll only need it once.
Thanks guys!
 

·
Registered
Joined
·
317 Posts
IIRC, for your year truck you stick the larger hollow square end into the hole to lower it, attaching all three pieces to it, then press the smaller square in into the jack handle then lower it.
You want the hollow square end to go over this square center bolt that drives the inner gear to lower and raise the tire.
[ame]http://www.amazon.com/gp/product/B00GHT8NAC/ref=s9_simh_gw_p263_d0_i3?pf_rd_m=ATVPDKIKX0DER&pf_rd_s=desktop-1&pf_rd_r=1YF2MCJGK1MATR3QPRE7&pf_rd_t=36701&pf_rd_p=1970559082&pf_rd_i=desktop[/ame]
 

·
nbs 2wd single cab
Joined
·
373 Posts
Discussion Starter #4
IIRC, for your year truck you stick the larger hollow square end into the hole to lower it, attaching all three pieces to it, then press the smaller square in into the jack handle then lower it.
You want the hollow square end to go over this square center bolt that drives the inner gear to lower and raise the tire.
http://www.amazon.com/gp/product/B0...rd_t=36701&pf_rd_p=1970559082&pf_rd_i=desktop
Hmmm, I'll give that a shot. I tried the jack driver with no luck.
Thanks
 

·
nbs 2wd single cab
Joined
·
373 Posts
Discussion Starter #5
IIRC, for your year truck you stick the larger hollow square end into the hole to lower it, attaching all three pieces to it, then press the smaller square in into the jack handle then lower it.
You want the hollow square end to go over this square center bolt that drives the inner gear to lower and raise the tire.
http://www.amazon.com/gp/product/B0...rd_t=36701&pf_rd_p=1970559082&pf_rd_i=desktop
Bigger than Sh!t, you were right, spare dropped right down. Thanks
 

·
Premium Member
Joined
·
6,277 Posts
:slap:
 

·
Premium Member
Joined
·
2,287 Posts

·
Premium Member
Joined
·
2,287 Posts
1 - 10 of 10 Posts
Top