GMC Truck Forum banner

1 - 20 of 45 Posts

·
GMFS Military Member
Joined
·
10,899 Posts
Discussion Starter #1
Ill try and sell this by itself now I guess. $70 shipped
 

·
Mossy Oak Pro Staff
Joined
·
2,668 Posts
Will you separate?
 

·
GMFS Military Member
Joined
·
10,899 Posts
Discussion Starter #7
Will you separate?
:hmm: SURE! :wave:
Will this work on my 01 mustang gt?

And can I stack it between my bed and my frame and use it as a body lift?
Yes and with mild trimming
Does it increase gas mileage?
if you run 2 sets
my bro wants it for sure...he's got the money in hand for it

will it fit an 08 sierra 2wd?
Let me know, send me a PM or something. My paypal is [email protected]
 

·
Mossy Oak Pro Staff
Joined
·
2,668 Posts
Can I buy 2 of them for each side and stack them?

:wave:
 

·
GMFS Military Member
Joined
·
10,899 Posts
Discussion Starter #10

·
Cartmans Critters
Joined
·
8,867 Posts
But wouldn't that be too much of an angle for your CV?
RC has 1" plate and 3 1/2" plates I think

so you could technically do the CCM spacer or bilstein leveling struts. Then throw in the 1" plate and you should be good

If you're 2wd it dont matter just trim your bump stop that the UCA would hit and maybe get some GMR UCAs for angle reasons and you're good to go
 

·
Mossy Oak Pro Staff
Joined
·
2,668 Posts
You can put a CCM on top and RC spacer plates on the bottom of your strut :read:
Ehhh wrong. I'm running the RC kit so I already have a spacer on my strut.

I was being sarcastic about stacking CCM's. I'm just giving Jameson a hard time.
 

·
.
Joined
·
2,325 Posts
Do I have to change the blinker fluid due to the added height this gives me? I know being elevated that high in the air has its funny affects on fluids and mechanics. If I dont have to change it I may be interested.
 

·
GMFS Military Member
Joined
·
10,899 Posts
Discussion Starter #18
bump
 
1 - 20 of 45 Posts
Top