GMC Truck Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2,289 Posts
Discussion Starter #1
Well today went to pull my truck out of my buddies garage after detailing it and my Compressor wouldn't turn on so checked all my wires and one was loose connected it and it still wont turn on. So I go under the hood and take a wire and just go right from the power wire on the compressor and go right to the battery to see if the clutch will kick in and nothing happens, So I grab my tester light and get as close to the end of the power wire as possible to see if there is power going to it and there is lights right up. By the way its a sandem compressor belt driven.

So what do you guys think do I need a new clutch on it is that why it wont turn on???
 

·
Registered
Joined
·
2,289 Posts
Discussion Starter #4
sounds like you already know the answer to this question:crazy:
Okay thats what I was thinking just thought I would get a few opinions. Is it hard to change a clutch out?
 
1 - 4 of 4 Posts
Top