[spootydlux4]

do i need keys to crank em or can i do it without em?

 

[BDZ71]

You can crank your stock keys. But you will be able to crank further with f*rd keys.

 

[spootydlux4]

im new to lifting shit but this isnt hard is it?

 

[Whifflebat]

Its not hard, check the tech article in the tech articles section.

 

[BDZ71]

Its not hard, check the tech article in the tech articles section.

:word: HERE is the link to that Tech article Whifflebat is talking about. You should find it very helpfull.

 

[tx marine]

or if you'd like a simple explination....
get a set of sockets(dont remember what size off the top of my head) and crawl under your truck, at the back end of the torsion bars you'll see a crosmember with a bolt on each side. lift your front end to get the weight off the springs. then tighten the bolts, that moves your keys up so that you'll sit higher. crank up the two, then put your truck back on the ground, measure both sides and repeat from the start till they are even. after that you should get your front end alligned.

 

[carterbeauford]

get a set of sockets(dont remember what size off the top of my head)

should be 18mm.

 

[00GMC4x4]

do i need keys to crank em or can i do it without em?

you can do without.