GMC Truck Forum banner

Cut front Bumper For fogs

1136 12
How should i cut out the fog light squares in the front bumper, its painted and i dont want it to chip off, then little by little the paint starts to chip off and everything just falls apart.

any idea?
1 - 13 of 13 Posts

·
TEAM FUEL MOTORSPORTS
Joined
·
8,236 Posts
I cut mine out with a razor knife... but then again its just the black plastic valance.

I'm not really sure what would work best for your valance?
 

·
Officially Tucking Tire
Joined
·
9,643 Posts

·
TEAM FUEL MOTORSPORTS
Joined
·
8,236 Posts
I was wondering about cutting with the dremel also. I wonder if it would "heat/seal" the edge of the painted plastic?
 

·
TROLL REVOLT of 2012
Joined
·
7,566 Posts
Discussion Starter · #9 ·
bought some clear today.... ill let you guys know how it came out.

edit: hey should i cut from the back of the bumper or front, does it even make any differance?
 

·
is Bi-Winning and a
Joined
·
15,745 Posts
I would tape it off and go slow. I cut my stock grill out with a dremel and it went very easily through the plastic so beware that it can get away from you quick if you dont keep it going slow...
 
1 - 13 of 13 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top