GMC Truck Forum banner

1 - 5 of 5 Posts

·
Newbie
Joined
·
113 Posts
Discussion Starter #1
I am looking to install a cutout after the y-pipe and on my catback magnaflow. question is since my magnaflow is stainless would getting a stainless cutout be the correct route to follow? and also since the exhaust is a 3" would a 3" cutout be able to be correctly welded up with no issues? thanks guys.
 

·
Newbie
Joined
·
113 Posts
Discussion Starter #3
thanks dick.

I know any metal can be welded. Reason I was asking was whether I should continue with the stainless theme or not.
 

·
14.18 SSS
Joined
·
78 Posts
IMO I would stick w/ stainless. Yes 3" is what you want if the is what you have.
 

·
Speed Holes
Joined
·
5,190 Posts
yeah, I don't know why you wouldn't go with the stainless if it is an option?

I actually went with a 2.5" DMH e-cutout, but that was partially my mistake on not planning ahead properly. It causes no problems though, works great!
 
1 - 5 of 5 Posts
Top