GMC Truck Forum banner

cutting notch

1945 Views 8 Replies 7 Participants Last post by  groundscraper
ok, i almost have all my parts gathered up to do my 3/6 drop. another week or so and i'll have my springs and shocks ( thanks, 5.3Vortec )

my question is how do you know where to cut the notch? do you unbolt the springs from the axle then raise the rear end until it hits the frame to mark the area that need to be removed, or is there another way? all my notch hardware consists of are two plates with the arc in them and two square pieces with a C-shaped piece inside them and two flat plates with 5 holes in it, one in each corner and one offset to one side in the middle.
1 - 1 of 1 Posts
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top