GMC Truck Forum banner

1 - 20 of 55 Posts

·
Registered
Joined
·
812 Posts
Discussion Starter #1
Hey guys, I drew up my own dimple dies because I can't afford most of them on the market. The ones I designed are for 1/8" max material and made from heat treated 4140 fully CNC machined. I will have pricing set next week and the goal is to make these affordable for just about anyone.

I will have two different sized sets available

Small set:
1/2", 1", 1-1/2", and 2"

Large Set:
1/2", 3/4", 1", 1-1/4", 1-1/2", 1-3/4", and 2"

This is a 1" die we ran on the manual lathe for me to test the design

On the left is 20ga, then 16ga, then 3/16. I designed it for 1/8" max but didn't have any in the shop.





 

·
Registered
Joined
·
2,806 Posts
Interested here
 

·
Registered
Joined
·
812 Posts
Discussion Starter #10
Ok guys I have pricing lined out finally

Small Set (4 piece): 1/2", 1", 1-1/2", 2" is $185 shipped in the US

Large Set (7 piece): 1/2", 3/4", 1", 1-1/4", 1-1/2", 1-3/4", 2" is $300 shipped in the US

Not sure just yet how long it will take me to get them made but I will ballpark it at about a month. Unless interested is extremely high I am going to start with only 15 sets of each. If you are interested let me know and I will get a list going and notify you when I actually have them in my hands and you can place your order at that time.
 
1 - 20 of 55 Posts
Top