GMC Truck Forum banner

door handle upgrade

698 6
i have read the whole thread that fast and bagged posted up about door handle upgrades (good thread btw.) i bought the buckets without the pulls and i am trying to switch my pulls into the new buckets. any advice on how to get the pin out that holds the pull to the bucket? trying to get this done today.
1 - 7 of 7 Posts

·
Registered
Joined
·
12,808 Posts
Glad you got them man. I cut the flared end off with a dremel tool. Just be real careful.

If you don't have a dremel you might be able to drill out the top part just start with a small bit and go bigger.
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top