GMC Truck Forum banner

1 - 3 of 3 Posts

·
...
Joined
·
2,451 Posts
Discussion Starter #1
i was talking to this guy on another site (not fsc) and he was saying it would be almost imposible to run a driveshaft to a 2 door blazer with 16" of lift without adding a divorsed case. Is this true?
 

·
Drive It Like Ya Stole It
Joined
·
6,656 Posts
I assume your talking about the front. It will be pretty steep unless you do run a divorced or clocked case. Look at running like a dual 1350 CV shaft. I would give high angle driveline a call.
 

·
...
Joined
·
2,451 Posts
Discussion Starter #3
it would be only 14" in the front, but i think he was talking about the rear. he has sas'ed obs 4 door hoe with 13" of lift and he says with a little more lift he would have some major problems
 
1 - 3 of 3 Posts
Top