GMC Truck Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
638 Posts
Discussion Starter · #1 ·
Ok heres the problem I wash cleaning the engine bay today and went to take off the cover but the bolt just turned so after wrestling with it and ripping out the rubber ring i finally got it off. The problem is tho the bolt is still stuck in the intake, does anyone have an idea of how to get it out? I used a vise and ratchet but it just spun. Heres a pic if your not sure what bolt im talking about. TIA
 

·
Registered
Joined
·
638 Posts
Discussion Starter · #4 ·
....Unless it got cross threaded somehow.. The threaded cert in the intake might come out with the bolt if you get too crazy.
Im thinking thats going to happen because its just spinning in my vice grip so im not sure what to do. Any other suggestions?
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top