GMC Truck Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
New to forum. Not that I would, but if I wanted to disable the cutout of my motor that occurs at about 98 mph, how would this be accomplished?
 

·
RIP Jason
Joined
·
4,089 Posts
a handheld programer such as hypertech or a custom tune like nelson or westers.
get a nelson tune :read:
 

·
Jason RIP
Joined
·
6,062 Posts
trg-s338 said:
New to forum. Not that I would, but if I wanted to disable the cutout of my motor that occurs at about 98 mph, how would this be accomplished?
Like zubyc said, a handheld programmer (plugs into the diagnostic port under the dash) or a custom tune to replace your current PCM module (easy swap under the hood) .. you'd be looking about $300-400 depending on which you get.
 
1 - 4 of 4 Posts
Top