GMC Truck Forum banner

1 - 3 of 3 Posts

·
GMFS founding member
Joined
·
4,009 Posts
Discussion Starter #1
so my drivers door panel squeaks badly around the handle and speaker grille because it's really flexible. i was thinking i could pop it off and stick some bondoglass and resin back there and make it solid, then plaster the whole thing with dynamat or something similar. would this work?
 

·
GMFS Senior OG Member
Joined
·
3,511 Posts
Stuff some carpet padding in it. After I install my exhaust, I had to insulate the plastic trim right below the rear window. Damn I hate rattles.
 

·
Registered
Joined
·
736 Posts
You could spray some of the spray cna insulation in there that expands, it would be pretty crappy but it would get the job done fast. and it wouldnt be noticable
 
1 - 3 of 3 Posts
Top