GMC Truck Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter #1
I have a 4/6 drop on a 04 ext cab silverado and i would like to put the boss 313's on there. I know this has been posted before and there is a person with a red CC that has them. here is the spec off of the website for the wheels. part# 3136-0962, 22x9.5 Chrome 6 on 5.5, Offset +40 mm, BSM 6.785. I would like to know if you have to roll the fenders back or anything extra to fit these wheels with a 265/35 tire. any input would be nice. Thanks.
 

·
Registered
Joined
·
48 Posts
Discussion Starter #5
If I do have to roll the fenders how hard is that to do. Could i do it myself or would i have to take it somewhere?.
 

·
Verbal Assault Specialist
Joined
·
1,321 Posts
do it your self. I jacked up my truck a lil with the stock tires on and placed a rubber mallet in there sideways that way the flat surfaces touched the fender and the tire and I lowered the truck slowly as my buddy held the hammer secure. Just do it little by little and work your way back and forth on the fenders. with a +40 you probably won't have to roll them but if you do this process should give you just enough room to clear the tires.
 

·
Registered
Joined
·
48 Posts
Discussion Starter #7
Thats an easy way of doing it. i would have never thought of doing it that way. i think that i am going to do it anyways just to be on the safe side. thanks for the advice.
 
1 - 7 of 7 Posts
Top