GMC Truck Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
429 Posts
Discussion Starter · #1 ·
A while back the rear brake line that runs down the frame behind gas tank rusted out as they all do. I replaced it drove for a while and now recently just replaced the front pads and rotors. For some reason the brakes are dragging very bad in the front now. Everything seemed fine when I swapped pads and it was all bleed when I did the brake line. I had lots of corrosion under the truck and all the bleeders we're corroded smooth. Think I have a sticking caliper or something else?
 

· Registered
Joined
·
732 Posts
sticking caliper, just a matter of time before it locks against the wheel after you use the brakes, you'll be driving and the truck will start pulling to that one side, then you'll say to yourself, what's burning?

for me my right front caliper stuck first. so i replaced all my calipers, rotors and pads. started bleeding brakes and upon first pressurization i blew that hard line running to the rear. blew right under the gap between the cab and bed.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top