GMC Truck Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
523 Posts
Discussion Starter #1
I got a 350 and tranny out of a 1993 Chevy Silverado. WIth the TBI and center bolt heads. My question is how hard is this to switch over to a carb and install it in a non electronic truck, like a 85 chevy? Will the tranny work?
 

·
Registered
Joined
·
36 Posts
Depending on your tranny, if it is a 4L60E then you will require a module that will operate your transmission if you stop using the ECM and use a carb. Check Summit or Jegs, im sure they have them, i remember coming accross them a while back
 

·
03 Tahoe
Joined
·
1,364 Posts
Yeah, you have a 700r4 as noted.

Even if you did have an electronic 4l60e you could still use the stock harness to just run the trans with it.

Any reason you wanna ditch the TBI for a carb?

Cameron
 

·
Registered
Joined
·
523 Posts
Discussion Starter #5
Well the truck its going in was a diesel. Its a 93 Chevy 3500 Dually. Most of the harness is gone thanks to and idiot who pulled the motor. I just don't want to have t fool with re wiring it for a gas TBI motor. Truck will be a 100% show truck, no A/C or any other goodies. Just a nice polished motor that gets it from point to a to point b. May see 1000 miles ayear
 
1 - 5 of 5 Posts
Top