GMC Truck Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Ok so I had a leak on my intake so I replaced the gaskets and decided to put an edelbrock tbi performer manifold in. I should mention I have a 87 3/4 ton chevy p/u with a fuel injected 5.7L small block 350. Anyway. I used my die grinder to get all the old gasket residue off and it is all sealed correctly. But when first started it idles fine and sounds great. The timing is right on and I have compression. But once it warms up or I put it in gear it stalls out. If I put it in drive and try to accelerate there is no power and it stalls.
Please help I love my truck and it breaks my heart to see her dead in the garage.
 
1 - 1 of 1 Posts
Top