GMC Truck Forum banner

intake ? on a 6.0

1168 Views 16 Replies 7 Participants Last post by  Kevin
i have a 6.0 and was wondering if i could use and ls intake manifold on it i have a typhoon intake manifold and wasnt sure if it would even work if anyone knows anything about it and has any info that would be great and also if anyone knows if the pacesetter long tubes would fit a 2500 6.0 i heard they do but wasnt sure
1 - 3 of 3 Posts

· Registered
Joined
·
12,642 Posts
All of it is a waste of time . Keep the stocker. As far as the pacesetters they will work fine but you obviously can't use the y-pipe.
 

· Registered
Joined
·
12,642 Posts
so the after maket intake isnt worth it even if i run n2o and how much nitrious could i put to a 6.0 with 100,000 miles on it
Well that all would depend on what your plans for the truck are. Honestly, it sounds like you are a step above being clueless(nothing wrong with that we all have to learn). I would suggest letting us know what your realistic plans for the truck are.
 

· Registered
Joined
·
12,642 Posts
im sorry im just gettin into the newer trucks havent had anything this new before i do drive it daily and have some stuff done to it a trick flow cold air and super chips tuner but i want to get rid of that to get an hp tune and i have a cat back with the dyno max x pipe muffler 3" if any of that helps i dont want to do internal motor work yet
If that's all you have planned then the stock truck intake will be just fine. It actually flows better than the ls1 intake. The ls6 intake is a joke for the cost to swap to it to see maybe a .1 improvement, and any aftermarket intake is going to be too expensive for the minimal gains you may see.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top