I'm wanting to wire up a switch inside and I know it should be simple but I just haven't looked at it yet and don't wanna tear to much apart looking since someone else has already done it, but where's the best place to go from in the cab to the engine bay? Is it easy to get through the firewall at a certain spot over another?
It easy to run wires in and out of cab on NBS?
1 - 3 of 3 Posts
Joined
·
130 Posts
You can run through the rubber seal on the firewall next to where the steering shaft runs through
From The Phone
From The Phone
1 - 3 of 3 Posts
