GMC Truck Forum banner
1 - 6 of 6 Posts

·
JUGS Racing
Joined
·
1,199 Posts
Well if it didn't shake before the u-joint then you know that its something that went wrong with doing the u-joint. Did you mark the driveshaft and yoke before you tore it apart?
 

·
Registered
Joined
·
20 Posts
Discussion Starter · #3 ·
I didnt do anything of that sort, Im pretty much new to anything mechanical to a vehicle, being this is the only truck i've owned that ive actually worked on my self. Could you give me more insight as to wat all that means?
 

·
Registered
Joined
·
549 Posts
It means use touchup paint/ marker/ etc to mark the orientation that the driveshaft was "bolted" to the pinion. I would try flipping the driveshaft 180* and reinstall it. Hopefully that will solve your problem, but if not I would tear it back down and pull the ujoint apart and check the ujoint & install
 

·
TCBCK
Joined
·
567 Posts
what they said and make sure all "4" clips go in
 
1 - 6 of 6 Posts
Top