[rawalters117]

Hey guys. Currently putting a lift on. The truck had a flip kit on it. How do I get the center pin for the plate on the leafs to flip? The new tapered blocks won't line up and the new u bolts are square, when the current ones are curved for the flip kit. Very urgent please any insight would be great


Sent from my iPhone using Tapatalk

 

[Bagged_Sierra]

have to use a couple of sets of C-Clamps to hold the spring pack together and then take a set of Vise-Grips to hold the top of the center pin and use a socket or wrench on the other end to loosen the nut, take out then put it back in opposite position.

 

[rawalters117]

have to use a couple of sets of C-Clamps to hold the spring pack together and then take a set of Vise-Grips to hold the top of the center pin and use a socket or wrench on the other end to loosen the nut, take out then put it back in opposite position.

Thanks a lot. This is happening tomorrow at some point so hopefully it isn't too awfully difficult.


Sent from my iPhone using Tapatalk