GMC Truck Forum banner

1 - 4 of 4 Posts

·
Duckslayer
Joined
·
10 Posts
Discussion Starter #1
So I have an idea and im not sure if it would work or not. I purchased the 5 button luxury control switch that fits the slot between the two cigarette lighters on my 08 1500. The switch has a 12 pin connector on the rear and a circuit board on the inside. It controls things such as pedal adjust, parking assist and heated washer fluid. My idea is to use this switch as my control panel for accessory lights (rear bumper, and front grill). Since im not a guru like some on here, does anyone have any suggestions as to how to go about this?
 

Attachments

·
This place sucks dicks
Joined
·
4,938 Posts
Need a pin out diagram to figure that out........maybe someone here has one. You'll also need the plug and wires.
 

·
Duckslayer
Joined
·
10 Posts
Discussion Starter #3
Well I have the plug and wire to make this work, I'm just not sure that I would be able to look at a diagram and decipher what goes where, that's where im going to need some input.
 
1 - 4 of 4 Posts
Top