GMC Truck Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
251 Posts
Discussion Starter · #1 ·
I got all my parts from tim yesterday so im up early to tackle this bitch today!

1. Does anyone a template for the MCG bolt in notch. NBS truck?

2. Does anyone have pics of the MCG flip kit installed? The bottom plates have two hole in them, that im a bit unsure about?

Thanks for the help!
 

·
Registered
Joined
·
654 Posts
If you want a template that bad, trace the notch out onto a piece of cardboard and punch out some circles for the bolt holes. No big deal at all.

What I did was install the flip kit, jack up the axle til it was close enough to the frame that I could mark the center of the notch, cut the notch in the frame accordingly, and install it.
 

·
Registered
Joined
·
251 Posts
Discussion Starter · #5 ·
no worries, after some more time on it everything is very simple. be back on the road tomorrow!!!! thanks for the replies!!
 
1 - 5 of 5 Posts
Top