GMC Truck Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,247 Posts
Discussion Starter #1
Truck was dropped at 3/5, 2" belltech spindles, drop struts set at 1". rear flipped at 5"

3 weeks ago, I pulled everything apart. Set the struts to 2" drop and lowered the rear to 6". Now it should sit at 4" drop in the front, 6" in the rear. However I measured before hand and after and it still sits dead at 34" in the front, and about .5" lower in the rear. Those are 3/5 measurements lol.. so it didn't move

I have been driving the hell outta it hitting every bump I could, yet its not sitting right. What did I mess up?

3/5
872389


"4/6" - hard to tell from those pics because its not on level ground
872390
 

·
Registered
Joined
·
1,247 Posts
Discussion Starter #3
Way clear of them.

I'm thinking it might be the 4wd coils in the front? I had a set off a 09 z71 and put my drop struts under them just so I could swap everything out with very little down time.

Looking at the two, the 4wd's look much thicker, maybe stiffer? Can anyone confirm?
 

·
Registered
Joined
·
2,390 Posts
My NNBS has always gave me hell. With Fox coilovers and new leafs I still differ 2” side to side.
 
1 - 4 of 4 Posts
Top