Joined
·
138 Posts
anyone with a bagged nbs chevy could you please measure from the center of your notch to the end of the frame. i want check an see if my notches were installed in the correct place.
nbs bagged. favor
1 - 15 of 15 Posts
Joined
·
138 Posts
bump
Joined
·
1,219 Posts
would but mine is backhalfed sorry bro..as long as its center over the axle you should be fine...
Joined
·
1,122 Posts
articulate the suspension in the rear and see if is gonna clear and then you'll know if you have a enough clearance
Joined
·
138 Posts
my truck is bagged already.... its two linked im switching to a 6 link and wanted to make sure the shop put my notches in the correct place beings that other stuff was over looked ..and before i drop 1300 on a link setup..
Joined
·
1,122 Posts
So if your truck is already bagged and we are assuming youre notched already then why wouldnt your notch be in the right place. your axle cant move that far back otherwise it will fall out of the yoke on the drive shaft.
Joined
·
138 Posts
i simply came in here to ask a favor of someone to pull me a few measurements just to double check things not to get technical with everything.. mabye im not clear?
Joined
·
2,528 Posts
So you wanted to ask a technical question but didn't want to get all technical? I would take any advise these guys have to offer, they know what they're doing. I agree with Jimmybonez, it can't really go back that far before your slip yoke falls out.
Joined
·
1,122 Posts
Listen my man im not tryin to be a dick, but youre not being clear at all besides you want measurements. from notch to where ever? lets start off by telling us if youre setup. clearly you got a 2 link but do you have a notch already in your frame. are you goin with the kp 6 link? anything would help us out man
Joined
·
138 Posts
.... my truck is bagged on 22s.. it is 2linked at the moment..... i am wanting to get a kp 6link.. i want to see if my notches were installed in the correct location because the shop that bagged it half assed everything else...i dont have a factory truck around to pull some measurements.. so if the notches are off like 2 or so inches im going to have to do some work..an im not going to drop 1300 bucks on the 6link.....it does not matter what i have now or what im planing on doing..
all i need is someone to do me a fav an pull a few measurements from the center of their notches to the end of their frame. THATS IT!
all i need is someone to do me a fav an pull a few measurements from the center of their notches to the end of their frame. THATS IT!
Joined
·
3,255 Posts
Is your axle in the center of the existing notch when laid out?
Joined
·
138 Posts
it will never be with the two link.....when laying out it pulls the axle forward towards the front of the notch......
Joined
·
1,122 Posts
Once again not being a dick but any amount of upward travel in the rear suspension is going to "pull" your axle forward because its coming from a stationary pivot point and travels on an arc not a straight line. So its pretty safe to say that when you install your 6 link its going to do the same thing and move the axel to the front of the notch. Your best bet is to install 6 link and move the notch if you want
about 37-1/2 inches.
1 - 15 of 15 Posts
