NBS parts (leftovers from 4.3 - 5.3 swap)

Did an engine swap on my truck and have some left over parts for sale.

PRICES ARE + SHIPPING!

5.3 parts:
-factory exhaust manifolds - $25
-factory water pump and thermostat - $25
-Factory fuel rails (return style) - $75
-AC lines (suction, discharge, & evap lines) - $30 PER line
-factory flywheel for 4L60E- $25
-Frame mounts 1/2 ton 2wd - $40
-box that holds ECU - $10\
-Factory 2004 ECU - $75
-Factory 2003 wiring harness (DBW), pigtails for low oil, crank position, and ac compressor are cut off, but i do have the pigtails. Also the wiring for the mass air flow meter, ac evap sensor, and both o2 sensors on PASSENGER side are also cut, and i DO NOT have these. - $75

4.3 parts:
-Complete pullout 4.3L engine, complete harness (no cuts!) and ECU. Comes with good clutch, flywheel, and pilot bearing, manifolds, good fan and fan clutch, motor mounts, heater hoses etc. 81,000 ORIGINAL miles out of my 2006 silverado. - $800
-Full K&N intake (tube, filter, adpter, heat sheild, original box and instructions) - $100
-(4) orginal o2 sensors (81,000 miles) - $20 a piece
-factory cabtack exhaust from a single cab short bed silverado. - $75
-Catalytic converters (were cut from orginal y pipe) - Make offer!
-Throttle cable (DBC) - $25
-Cruise control cable and module - $75
-Frame mounts 1/2 ton 4wd - $40
-AC Lines (suction & discharge) - $30 each
-Great condition fan shroud - $35

May have more, but this is all i can think of at the moment. Can get pictures. Everything is located in Conroe, TX.