GMC Truck Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
170 Posts
Discussion Starter · #1 ·
I am finally ready to wire 2 10" subs in a down-fire box from Subthump in my 2000 Silverado. I am running 4 ga wire to my amp. How do I put the power wire through the kick panel and under the door sill to run it back to the amp on the back wall? Are they just pull up or is there a trick to remove these parts to put the wire underneath? I don't want to pluck up my truck. I know I have to run the power wires down one side and the amp connection wires and the remote wire down the other side . Any other help would be greatly appreciated. Thanks in advance.
 

·
Registered
Joined
·
158 Posts
I ran my 4 Ga through an existing rubber grommet in the firewall, then under the driver's side kick panel, and door sill. The door sill pulls up, and the kick panel pulls back toward you. Just be careful, and don't use too much force.
 
1 - 3 of 3 Posts
Top