GMC Truck Forum banner
1 - 9 of 9 Posts

· Registered
Joined
·
495 Posts
Discussion Starter · #1 ·
I am about to buy a boat and I won't be able to tow it without a helper spring setup (I have a DJM 4/6).

What is a good helper spring setup for this application for my flipped axle?

I want something that wont take forever to inflate and something that will be durable.

Any suggestions?

Its an 18' ski boat.
 

· Registered
Joined
·
495 Posts
Discussion Starter · #3 ·
OK. Now I have decided on the Slam Air kit from Airlift. I want an onboard compressor too though.

I want to get the digital 2way gauge from air ride too.

SHould i use a 1gal tank + compressor or just an onboard compressor?
 

· Burning Rubber
Joined
·
1,019 Posts
Just get a compressor, Single Needles guage and some 3/8" line and a T-fitting to dual 1/4 inch line. The kit probably comes with most of the hardware... No real need for a tank. Just get one single Dump valve for both bags.
 

· Jason RIP
Joined
·
9,790 Posts
Chris99GMC said:
Just get a compressor, Single Needles guage and some 3/8" line and a T-fitting to dual 1/4 inch line. The kit probably comes with most of the hardware... No real need for a tank. Just get one single Dump valve for both bags.
I wouldn't waste the money on an electric valve, I'd say just get a manual paddle control ... have you even looked at the kit that Air Lift makes?



http://www.airliftcompany.com/loadcon2.htm
 

· Burning Rubber
Joined
·
1,019 Posts
I need some helper bags... I have a compressor... Just looking into the cheapest most efficient way. I 1 gal. tank could be nice.
 

· Jason RIP
Joined
·
9,790 Posts
SITNLO said:
I heard it takes like 2 minutes to air up with the LOAD controller I

Would the Load Controller ! work faster, or would it be overkill. and also would a 1 gallon tank hurt?
You have to question yourself what you are using this for, how often are you going to be pulling the boat? 2 minutes isn't that big deal when loadign the boat up and getting ready to go to the water.
 
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top