GMC Truck Forum banner

Need Helper Spring Recommendations

748 Views 8 Replies 4 Participants Last post by  SITNLO
I am about to buy a boat and I won't be able to tow it without a helper spring setup (I have a DJM 4/6).

What is a good helper spring setup for this application for my flipped axle?

I want something that wont take forever to inflate and something that will be durable.

Any suggestions?

Its an 18' ski boat.
1 - 2 of 2 Posts

· Jason RIP
Joined
·
9,822 Posts
Chris99GMC said:
Just get a compressor, Single Needles guage and some 3/8" line and a T-fitting to dual 1/4 inch line. The kit probably comes with most of the hardware... No real need for a tank. Just get one single Dump valve for both bags.
I wouldn't waste the money on an electric valve, I'd say just get a manual paddle control ... have you even looked at the kit that Air Lift makes?



http://www.airliftcompany.com/loadcon2.htm
 

· Jason RIP
Joined
·
9,822 Posts
SITNLO said:
I heard it takes like 2 minutes to air up with the LOAD controller I

Would the Load Controller ! work faster, or would it be overkill. and also would a 1 gallon tank hurt?
You have to question yourself what you are using this for, how often are you going to be pulling the boat? 2 minutes isn't that big deal when loadign the boat up and getting ready to go to the water.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top