GMC Truck Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
148 Posts
Discussion Starter #1
Hello

well I"m trying to bag my tahoe. and it's 4x4. well I don't have $ to buy new onw and 2wd, I'm gonna go ahead and bag this truck anyway.
I got the rear setup figured out, I'll be using the airride kit. I confirmed that it will work. guy I emailed was very helpful.

so for the front.
I'm going to remove axle, etc out of the tahoe.
I first was thinkng of using hub from 99 which has 6 bolt pattern and also hub is 3 bolt to the spindle(knockle) part. so I think that might fit.

but

I found this guy from one of the fsc member emailed me.
http://www.streetsourcemag.com/viewownerprofile.aspx?profileid=31064

he did convert the 4wd to 2wd.
I see that lower control arm is oem. I'm trying to figure out the spindle. hub, and upper.

if any one has input for me I"ll be very appriciate.
 

·
layin big rubber
Joined
·
1,456 Posts
the guy with the 91 on fsc never got the truck to lay out tho, but nbs trucks are bigger then obs trucks so maybe it can lay out with something like a 20
 

·
Registered
Joined
·
148 Posts
Discussion Starter #4
Yep I read his post. he was very helpful. I really don'tmind taking forn axle off. and I'm planning on laying frame.
since my front doesn't engage anyway and don't really needed 4wd even in winter.

yeah I'm keep doing research on it and find out as much and write up on converting to 2wd when I'm done reaserching.
 
1 - 4 of 4 Posts
Top