GMC Truck Forum banner

1 - 11 of 11 Posts

·
TurtlePusher
Joined
·
500 Posts
Discussion Starter #1
Well i have been busy doin the super C-notches, rear sway bar, and also got a new cowl hood.

Im sitting at 5/8 and had to run helper bags because it was bottoming out with the little notch. When i bought the new wheels and tires, they were too wide and wouldnt fit with the bags there. so i had to have a Super C built. I would still like to go another inch down in the rear to make it sit level, or just go ahead and do bags....not sure yet. anyways, on to the pics!!!!!!!!

original notches (in FOR SALE section)
DSC00209.jpg

DSC00212.jpg

new ones built from 2" square tubing and 3"x1/4" plate steel
DSC00227.jpg

DSC00224.jpg

DSC00223.jpg

Cut out bed crossmember where the notch will be
DSC00217.jpg

rear sway bar installed
DSC00228.jpg

a shot without the bed
DSC00230.jpg

DSC00231.jpg

bed back on
DSC00239.jpg

DSC00237.jpg

DSC00236.jpg
 

·
TurtlePusher
Joined
·
500 Posts
Discussion Starter #5
yeah i was kinda wandering that. the guy that did it wasnt there when i picked it up. it seems pretty strong though.
 

·
TurtlePusher
Joined
·
500 Posts
Discussion Starter #7
31x10.50/15
 

·
Registered
Joined
·
131 Posts
yeah i was kinda wandering that. the guy that did it wasnt there when i picked it up. it seems pretty strong though.
Gotcha wasnt trying to be a dick or anything just wanted to make sure that it wouldnt fail on a fellow truck guy cuz thats never good. But nonetheless keep up the good work man. Should be beautiful when its all said and done.:bowtie:
 

·
Member # 625
Joined
·
968 Posts
Is it just me or does the truck look "bent" between the bed and cab?
 

·
TurtlePusher
Joined
·
500 Posts
Discussion Starter #11
thaniks for the comments guys. Paint and an engine build are next
 
1 - 11 of 11 Posts
Top