GMC Truck Forum banner
1 - 6 of 6 Posts

·
Iron Block LS2
Joined
·
192 Posts
Discussion Starter · #1 ·
but just a project I have been working on.

This will be my drag queen.:crazy:

1fa1ga13c3n83m83o98c5eb560e0a717011.jpg

0321091704.gif

0321091843.gif

0321091852.gif

0330091649.gif

JE pistons
0331091524a.gif

Eagle H-beam rods
0331091651.gif

Stage 2 Turbo
0529092003a.gif

Pulled the motor
0529091958.gif

Dirty Engine Bay
0529091958a.gif

Cleaned up
0530091451.gif

0530091451a.gif

0530091453a.gif

0530091453b.gif

Painted Engined bay
0601091625.gif

0601091625a.gif

0601091626.gif

Gotta be safe
0530091454.gif


I got a lil civic with nitrous that I run to. But there aint much to it. Just a motor swap with header and full exhaust with no cat. Runs 15 flat. I will soon find out what it runs with spray here in the next few week.

DSC02435-1.jpg

DSC02432.jpg
 

·
Iron Block LS2
Joined
·
192 Posts
Discussion Starter · #3 ·
Well I should have given a lil more info. I got the motor and trans that is already fully built with about 4000 miles, FOR FREE.:D It all came out of a wrecked neon. The good thing is we know the guy who built it so we knew what was in it long ago. Cant get a hold of the guy now.

They spent a ton of money on the build. The trans has all the good stuff in it like an LSD shift kit and I want to say it has a stall converter in it aswell but I wont know for sure till I get it back on the road.

The motor has a crane cam all new valvetrain, 8.5-1 or 8.8-1 pistons. Port and polish head. So all in all, $600 into the project aint bad. IMO
 

·
The early stache
Joined
·
2,503 Posts
Well I should have given a lil more info. I got the motor and trans that is already fully built with about 4000 miles, FOR FREE.:D It all came out of a wrecked neon. The good thing is we know the guy who built it so we knew what was in it long ago. Cant get a hold of the guy now.

They spent a ton of money on the build. The trans has all the good stuff in it like an LSD shift kit and I want to say it has a stall converter in it aswell but I wont know for sure till I get it back on the road.

The motor has a crane cam all new valvetrain, 8.5-1 or 8.8-1 pistons. Port and polish head. So all in all, $600 into the project aint bad. IMO
Sounds like a lot of bang for your buck IMO.
 
1 - 6 of 6 Posts
Top